Auto Pages: 1995 Chevrolet Corvette LT1 Coupe (C4)

1995 Chevrolet Corvette LT1 Coupe (C4)

Modifications   ·   Pictures   ·   Wanted   ·   Credits

C4 Corvette LT1 Coupe

I became the (estimated) fifth owner of my black on grey 'Vette on August 29, 2003. Gerri, the previous owner, certainly didn't treat the car as I intend. Other than a few minor cosmetic issues and a few significant, but disclosed, mechanical ones, the car was quite clean.

Certainly this car is not the expensive, high-tech machine that my 2002 BMW M3 is, nor is it as refined or exotic as was my 1990 Porsche 928 GT. What it is, that those cars are not, is an extremely affordable, reliable sports car. I have nerve damage to my right leg and foot, so I can no longer drive a stickshift (I use my left leg to drive). The C4 automatic transmission, though not nearly as advanced or as much fun as the BMW SMG, will at least allow me to drive the car, hopefully without mechanical failures.

In the Corvette's favor are a number of factors. By design, the car has a very low center of gravity. It's fairly wide and accomodates huge wheels and tires, so it can generate prodigious lateral grip. The car is not as light as I'd like, but it still weighs no more than the BMW or the Porsche I drove previously. The 52% front/48% rear weight distribution is quite good, and can be improved slightly with modifications. The stock 5.7 liter (350 cubic inch) pushrod V8 (the LT1) makes 300 horsepower before any modifications. With some updates to the suspension and brakes and a few doodads to keep the fluids running cool, it should be quite an enjoyable car.

Unfortunately, the automatic transmission could be better-suited to my driving. I'm sure I will, at some point, upgrade to a more advanced system with higher torque capacity. My car also has the 2.75 rear end, which is too high a ratio (too low a number) to give me the best acceleration. I frankly don't care if my top speed is 150 mph or 180 mph.


  Modifications

The primary goal of all the following modifications has been to increase reliability and handling. My priorities were reliability, brakes, handling, acceleration, in that order.

Please see the Credits (below) for details.


Suspension
Brakes
Tires & Wheels
Engine & Transmission
Safety & Comfort

[top of this page]


  Performance
    Factory Specs   Modified    
Horsepower
(at crank)
  300 hp at 5000 rpm   360 hp @ 5300 rpm  
Dyno

Modified

Dyno

Factory Specs
Horsepower
(at wheels)
  na   304 hp @ 5300 rpm  
Torque
(at crank)
  340 lb-ft. @ 4000 rpm   380 lb-ft @ 4100 rpm  
Torque
(at wheels)
  na   327 lb-ft @ 4100 rpm  
0 to 60 mph
acceleration
  5.1 sec.   4.8 sec. est.  
1/4 mile   13.7 sec.   tbd  
top speed
 
  155 mph limited (161 mph)   170 mph  
Weight
 
  3404 lbs.   3300 lbs. approx.  
[top of this page]


  Pictures
  Coming soon . . .

Concours d'Elegance and Concorso Italiano:
  Concorso Italiano 2002
  Concorso Italiano 2000
  Concorso Italiano 1999
  Concorso Italiano & Monterey Historics 1998


I traditionally attend the annual Concours d'Elegance at Pebble Beach (Carmel), California. There are also the (usually more exciting) Concorso Italiano at Quail Lodge, the Monterey Historic Car Races at Laguna Seca, and the Monterey Sports Car Auction at the Doubletree Hotel. See my Events Page for other car-related events.
[top of this page]


  Parts For Sale

I hope to sell the following:

  Credits
Well Oiled Most of the work was done at Well Oiled in Los Angeles, California. Miguel did the majority of the work, while Dave Cooke, co-owner, advised us. The suspension installation is detailed here. I did as much of the work as I could, which I'd estimate at 40% or so. Well Oiled allowed me to use their facilities and to claim a bay there for about two weeks straight. Their pricing was quite reasonable. I think we all had a good time with the project.

DRM The majority of the mods were recommended by and purchased through Doug Rippie Motorsports of Buffalo, Minnesota. Randy made himself available for my very frequent questions, as did Tim. Randy actually came out to Los Angeles, in part to help me complete the install of my front brake calipers and then test the car out. His dedicatioon and helpfulness are unmatched in my experience. Their products are of extremely good quality and are a great value. Their advice was invaluable.

See my Corvette Links page for the details of which companies provided products and services.

[top of this page]




Copyright © 2003-2004 John Turkel. All rights reserved. Not affiliated with or endorsed by General Motors Corp. Chevrolet and Corvette are registered trademarks of General Motors Corp. All trademarks are the property of their respective holders. This material is for entertainment purposes only.

Last Modified November 19, 2004.

/